A further level drop to the red zone (Red) will switch the alarm relay after a time delay of 20 sec / 120 sec. When the level reaches the yellow zone (Yellow) the TR starts filling after a time delay of 10 sec. The sight glass of each device is divided into three operational zones. Adapters suitable for various types of compressors.Self-contained unit with oil level sensor and integral solenoid to manage oil level supply.Easy installation by sight glass replacement and front/side mounting without nuts.SPDT output contact for compressor shut-down or alarming, rating 230VAC/3A.3-Zone Level Control using precise hall sensor measurement not prone to errors caused by foaming, or light, such as optical sensors.IP65 rating with molded housing and cable assemblies.TR5 compatible with transcritical CO 2 system and R410A.TraxOil TR4-5 Installation Instructions.TR4-5 Models and Compressor Compatibility Listing.Recommended by leading compressor manufacturers.Easily removable inlet fitting with built-in filter screen.Set point levels use true levels with no timing overruns.Tamperproof, cannot be adjusted in field.Danfoss coil and enclosing tube complete with internal solenoid seat.Waterproof cables with no wiring at TraxOil unit.Meets European RoHS and WEEE directives.CE approved, EMC emissions and immunity.An A-7 or Y11236C valve is not required with a TraxOil Electronic OLC.TR5 is specially adapted to the requirements of transcritical CO 2 systems and must be used with dedicated types of CO 2 adapters.Soak 30-60 minute in the Cleantrax Hoof Boot. How to use: Mix entire 25 gm bottle with a gallon of water. In most cases, only one treatment is required. TR4 is developed for all traditional refrigerants and subcritical CO 2. Cleantrax Hoof Cleaner is a deep penetration hoof cleanser proven to be effective in eliminating white line, seedy toe, thrush and abscesses.For application in refrigeration systems according to EN 378. The hall sensor converts these magnetic field changes into an equivalent signal, which is used by the internal electronic to show the actual oil level with LEDs and activate the integrated solenoid valve to feed missing oil directly into the compressor sump. A magnetic float changes its position according to the oil level. All versions use a hall sensor to measure the oil level.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |